The processing of metal stamping parts is a requirement for bending parts
1. The shape of the bending part should be as symmetrical as possible, and the bending radius should not be less than the minimum bending radius allowed by the material.
2. The curved side is too short to form, so the straight part of the curved side should be made H>2δ. If H is required to be very short, it is necessary to leave an appropriate margin to increase H, and then cut off the added metal after bending.
3. When bending parts with holes, in order to avoid the deformation of the holes. The second is the requirement for deep drawing.
4. The shape of metal stamping parts should be simple and symmetrical, and the depth should not be too large. In order to minimize the number of deep drawing, easy to form.
5. The fillet radius of metal stamping parts does not increase the process procedure. Otherwise, it will increase the number of deep drawing and shaping work, and also increase the number of molds, and it is easy to generate waste and increase costs.
Whether the die used for metal stamping parts uses a spring-loaded discharge plate or a fixed discharge plate depends on the size of the discharge force.
Previous:Application fields of metal tensile parts
Next:No next record